Installation
5 Docs
01 Mounting
Last Updated: April 17, 2026Mounting Once you’ve confirmed sensor operation and planned your layout, you’re ready to mount the TankMaster and attach the sensors to the tank. Mounting the TankMaster Sending Unit Select a location Mount the TankMaster in a dry location that will stay dry, such as inside the RV interior or in a protected storage compartment. The...
02 Mounting the Sensors
Last Updated: April 17, 2026Mounting the Sensors Each TankMaster includes four pre-wired threshold sensors for one tank. These should be installed vertically along the side of the tank using the supplied adhesive pads. Prepare the tank surface Select a smooth, flat area of the tank wall. Clean the area to remove any dirt, oil, or residue. Allow the surface...
03 Power Connection
Last Updated: April 17, 2026Power Connection Plug the USB-C power cable into the TankMaster unit Connect the other end to a 5 V DC USB power source, such as an RV’s 12 V-to-5 V DC converter, a vehicle USB port, or a USB battery pack. When powered, the LEDs will flash to indicate operation. LED Color Function 1 Red...
04 Sealing the TankMaster Unit
Last Updated: April 17, 2026Sealing the TankMaster Unit The TankMaster control unit is not waterproof and must be installed in a protected environment. In installations where exposure to moisture, dust, or road spray is possible, the enclosure must be properly sealed. The TankMaster enclosure uses a rabbeted lid design, which requires sealing at specific points to prevent moisture intrusion....
05 Post-Installation Check
Last Updated: April 17, 2026Post-Installation Check Power and Connectivity Plug the USB-C power cable into the TankMaster unit. Confirm that the Status LED (red) is flashing to indicate normal operation. Verify that the Bluetooth (blue) and Wi-Fi (green) LEDs indicate connection as expected (e.g., flashing or solid). Open the RiVöt TankMaster App to confirm that the unit appears and...